Instructions For a Vehicle CD-MP3 Player Installation
View PDF | Print View
by: Jack Wylde
Total views: 8
Word Count: 350
Bookmark 
Keywords: CD , player , mounting , installing , car , stereo , car , audio , powernetshop.at , cars , vehicles ,
Here is the list of the things that you will need for completing the switch over; wire strippers, car stereo wiring connectors, 20 vinyl butt splices that are insulated awg 16-14, needle nose or combination pliers and 1 CD player dash install kit.
Remove about quarter to 1/8 of the total insulation from the ends of each wire coming out of the disk player. Repeat this task to the wires coming out of the car stereo wiring connector. Avoid damaging the wires when removing the insulation. If the wires get damaged then it is necessary to replace them.
Insert an end of the orange wire coming out of the wiring connector of the car stereo into the vinyl insulated butt splicer. Now close this side of the splicer. This can be easily done using the nose pliers. Make sure that the butt splicer holds the wire firmly. Now insert the end of the orange wire that is coming out of the rear end of the CD player into the other end of the butt splicer and close this end with the use of the nose pliers. Be sure that there are no loose connections and the wire is held firmly by the butt splicer. Repeat this step for all the wires that can be seen in wire connecting the stereo. Make sure that each wire is matched very well with the similar colour and size of the player.
With the help of your car owner
About the Author
Find the best Auto parts at bargain prices and much more information on Car Audio for the right music system. Powernetshop.at Erfahrungen have the best product evaluation on the internet.
Source: www.isnare.com
EXO spy - articles
Rating: Not yet rated